Any new insights, recommendations, or documentation for configuring Triad RackAmp 700 DSP amps? Its been almost a year since I was troubleshooting my Triad subs with their then-new 700-series DSP amps. As noted back in October, the key problems are basically overcome. Dawn graciously shared the Triad 700 quick reference which helped a lot. But it still leaves a lot to guesswork, not explaining the details of the settings parameters or how to tune them for the specific Bronze or Silver subs (much less their use with driven by a modern Audyssey-capable pre-amp).


Related: The pre-amp loses some key settings after losing power (that is, unplugged from wall, I think; not normal low-power "off" mode). Is there a way to program settings in a non-volatile memory setting to avoid this hiccup?


Thanks!


FWIW, these are my current settings:
Dual In-Wall Bronze
Volume: -07 dB
Input Source Select: XLR
Preset Selection: Cinema
Display Brightness: High
Enter Code: <><
IP Address: 0.0.0.0
Current Sub Model EQ: Bronze InWall
Phase: 00
Sub Lowpass Filter: 120 Hz
Sub Lowpass Slope: 48
Sub Highpass Filter: 50Hz
Sub Highpass Slope: 48
Line Output Highpass: Thru
Line Highpass Slope: NA
Route Delay to: Off
Power On Method: Sense
Sense On Threshold: 06mV
Sense Off in Minutes: 20


Single In-Wall Silver
Volume: -03 dB
Input Source Select: XLR
Preset Selection: Cinema
Display Brightness: High
Enter Code: <><
IP Address: 0.0.0.0
Current Sub Model EQ: Silver InRoom
Phase: 00
Sub Lowpass Filter: 60 Hz
Sub Lowpass Slope: 48
Sub Highpass Filter: 60Hz
Sub Highpass Slope: 48
Line Output Highpass: 120Hz
Line Highpass Slope: 48
Route Delay to: Off
Power On Method: Sense
Sense On Threshold: 06mV
Sense Off in Minutes: 20